wra-zmd-6w&wrb-zmd-6w wra-zmd-6w&wrb-zmd-6w wra-zmd-6w&wrb-zmd-6w wra-zmd-6w&wrb-zmd-6w wra-zmd-6w&wrb-zmd-6w wra-zmd-6w&wrb-zmd-6w wra-zmd-6w&wrb-zmd-6w wra-zmd-6w&wrb-zmd-6w s s eries eries http://www.microdc.cn technical enquiries-email:tech@microdc.cn tel:0086-20-86000646 page 1 of 3 order code input output efficiency (%,typ) voltage (vdc) voltage (vdc) current (ma) nominal range max. * max . min . wra2405zmd-6w 24 9-36 40 5 600 60 80 wra2412zmd-6w 24 9-36 40 12 250 25 82 wra2415zmd-6w 24 9-36 40 15 200 20 84 wra2424zmd-6w 24 9-36 40 24 125 13 82 wrb2405zmd-6w 24 9-36 40 5 1200 120 80 wrb2412zmd-6w 24 9-36 40 12 500 50 82 wrb2415zmd-6w 24 9-36 40 15 400 40 84 WRB2424ZMD-6W 24 9-36 40 24 250 25 82 wra4805zmd-6w 48 18-72 80 5 600 60 80 wra4812zmd-6w 48 18-72 80 12 250 25 82 wra4815zmd-6w 48 18-72 80 15 200 20 84 wrb4805zmd-6w 48 18-72 80 5 1200 120 80 wrb4812zmd-6w 48 18-72 80 12 500 50 82 wrb4815zmd-6w 48 18-72 80 15 400 40 84 *input voltage can 't exceed this value, or will cause the permanent damage. model model model model model model model model selection selection selection selection selection selection selection selection wra wra wra wra wra wra wra wra 24 24 24 24 24 24 24 24 05 05 05 05 05 05 05 05 z z z z z z z z m m m m m m m m d d d d d d d d - - - - - - - - 6 6 6 6 6 6 6 6 w w w w w w w w product series input voltage output voltage 1st wide ( 4 :1) input range metal shield dip package style rated power 6w, 4:1 wide input, isolated & regulated dual & single output dc-dc converter features features features features features features features features dip package 1500vdc isolation short circuit protection (automatic recovery) operating temperature: -40 to +85 internal smd construction metal shielding package industry standard pinout no heat sink required mtbf>1,000,000 hours rohs compliance applications applications applications applications applications applications applications applications selection selection selection selection selection selection selection selection guide guide guide guide guide guide guide guide the w r a_ z md-6w & w r b_ z md-6w series are specially designed for applications where a wide range input voltage power supplies are isolated from the input power supply in a distributed power supply system on a circuit board. these products apply to: 1) where the voltage of the input power supply is wide range (voltage range 4:1); 2) where isolation is necessary between input and output(isolation voltage 1500vdc); 3) where the regulation of the output voltage and the output ripple noise are demanded. common common common common common common common common specifications specifications specifications specifications specifications specifications specifications specifications parameter test conditions min. typ. max. units storage humidity 95 % operating temperature -40 85 storage temperature -55 125 temp. rise at full load 40 lead temperature 1.5mm from case for 10 seconds 300 cooling free air convection short circuit protection continuous, automatic recovery case material aluminum mtbf 1000 k hours weight 15 g microdc microdc microdc microdc reserves reserves reserves reserves the the the the copyright copyright copyright copyright isolation isolation isolation isolation isolation isolation isolation isolation specifications specifications specifications specifications specifications specifications specifications specifications parameter test conditions min. typ. max. units isolation voltage tested for 1 minute and 1 ma max 1500 vdc isolation resistance test at 500vdc 1000 m ? isolation capacitance input/output, 100khz/1v 100 pf
wra-zmd-6w&wrb-zmd-6w wra-zmd-6w&wrb-zmd-6w wra-zmd-6w&wrb-zmd-6w wra-zmd-6w&wrb-zmd-6w wra-zmd-6w&wrb-zmd-6w wra-zmd-6w&wrb-zmd-6w wra-zmd-6w&wrb-zmd-6w wra-zmd-6w&wrb-zmd-6w s s eries eries http://www.microdc.cn technical enquiries-email:tech@microdc.cn tel:0086-20-86000646 page 2 of 3 output output output output output output output output specifications specifications specifications specifications specifications specifications specifications specifications parameter test conditions min. typ. max units output power see above products program 0.6 6 w line regulation (at full load) input voltage from low to high 0.2 0.5 % load regulation form 10% to 100%load 0.5 2 * % positive output voltage accuracy refer to recommended circuit 1 3 % negative output voltage accuracy refer to recommended circuit 3 5 % temperature drift (vout) refer to recommended circuit 0.02 %/ ripple** 20mhz bandwidth 30 50 mvp-p noise** 20mhz bandwidth 75 150 mvp-p switching frequency 100% load, input voltage range 300 khz * dual output models unbalanced load: 5 %. **test ripple and noise by p arallel cable method. see detailed operation instructions at testing of power converter section, application notes. application application application application application application application application note note note note note note note note 1) 1) 1) 1) requirement requirement requirement requirement on on on on output output output output load load load load in order to ensure the product operate efficiently and reliably, in addition to a max load (namelyull load), a minimum load is specified for this kind of dc/dc converter. make sure the specified range of input voltage is not exceeded, the minimum output load no less than 10% load. if the actual load is less than the specified minimum load, the output ripple may increase sharply while its efficiency and reliability will reduce greatly. if the actual output power is very small, please add an appropriate resistor as extra loading, or contact our company for other lower output power products. 2) 2) 2) 2) recommended recommended recommended recommended circuit circuit circuit circuit all the wra_zmd-6w & wrb_zmd-6w series have been tested according to the following recommended testing circuit before leaving factory. this series should be tested under load (see figure 1). if you want to further decrease the input/output ripple, you can increase capacitance properly or choose capacitors with low esr. however, the capacitance should not be too high, or may cause start-up problem. for every channel of output, provided the safe and reliable operation is ensured, the greatest capacitance of its filter capacitor sees (table 1). general: cin: 24v&48v 10 f~47 f cout: 10 f/100ma 3) 3) 3) 3) input input input input current current current current while using unstable power source, please ensure the output voltage and ripple voltage do not exceed indexes of the converter. the preceding power source must be able to provide for converter sufficient starting current ip (figure 2). general: ip 1.4*iin-max 4) 4) 4) 4) no no no no parallel parallel parallel parallel connection connection connection connection or or or or plug plug plug plug and and and and play play play play typical typical typical typical typical typical typical typical temperature temperature temperature temperature temperature temperature temperature temperature curve curve curve curve curve curve curve curve recommended recommended recommended recommended recommended recommended recommended recommended circuit circuit circuit circuit circuit circuit circuit circuit
wra-zmd-6w&wrb-zmd-6w wra-zmd-6w&wrb-zmd-6w wra-zmd-6w&wrb-zmd-6w wra-zmd-6w&wrb-zmd-6w wra-zmd-6w&wrb-zmd-6w wra-zmd-6w&wrb-zmd-6w wra-zmd-6w&wrb-zmd-6w wra-zmd-6w&wrb-zmd-6w s s eries eries http://www.microdc.cn technical enquiries-email:tech@microdc.cn tel:0086-20-86000646 page 3 of 3 outline outline outline outline outline outline outline outline dimensions dimensions dimensions dimensions dimensions dimensions dimensions dimensions footprint footprint footprint footprint footprint footprint footprint footprint details details details details details details details details mechanical mechanical mechanical mechanical mechanical mechanical mechanical mechanical dimensions dimensions dimensions dimensions dimensions dimensions dimensions dimensions recommended recommended recommended recommended recommended recommended recommended recommended footprint(top footprint(top footprint(top footprint(top footprint(top footprint(top footprint(top footprint(top view) view) view) view) view) view) view) view) microdc professional power module,inc. tel:0086-20-86000646 e-mail:tech@microdc.cn website:http://www.microdc.cn microdc professional power module,inc.makes no representation that the use of its products in the circuits described herein, or the use of other technical information contained herein, will not infringe upon existing or future patent rights. specifications are subject to change without notice. ? 2010 microdc professional power module, inc. guangzhou rohs rohs rohs rohs compliant compliant compliant compliant information information information information this series is compatible with rohs soldering systems with a peak wave solder temperature of 300 c for 10 seconds. the pin termination finish on the sip package type is tin plate, hot dipped over matte tin with nickel preplate. the dip types are matte tin over nickel preplate. both types in this series are backward compatible with sn/pb soldering systems. reach reach reach reach compliant compliant compliant compliant information information information information this series has proven that this product does not contain harmful chemicals, it also has harmful chemical substances through the registration, inspection and approval. tube tube tube tube tube tube tube tube outline outline outline outline outline outline outline outline dimensions dimensions dimensions dimensions dimensions dimensions dimensions dimensions note: 1. the load shouldn't be less than 10%, otherwise ripple will increase dramatically. 2. operation under 10% load will not damage the converter; however, they may not meet all specification listed. 3. capacitor max load tested at input voltage range and full load. 4. all specifications measured at ta=25 , humidity<75%, nominal input voltage and rated output load unless otherwise specified. 5. in this datasheet, all the test methods of indications are based on corporate standards. 6. only typical models listed, other models may be different, please contact our technical person for more details.
|
